Orbit Turntable setup instructions
Follow these simple steps to get your Orbit Turntable up and running. For help with terminology, check out the diagram at the bottom of this page.
Place the platter on top of the center spindle. Then place the mat on top of the platter.
Wrap the belt around the pulley and platter. Rotate the platter as you install to maintain tension.
Slide the dust cover onto its hinges.
Connect the power adapter to the power jack on the back of the turntable. Then use the included RCAs to connect to your amp or powered speakers.
Gently remove the stylus cover. Always slide the cover forward - do not pull it down.
If you have the built-in preamp, you can turn it on or off (complete bypass) using the switch on the back of the turntable.
If you have a cue lever, it can be installed and removed by sliding it on or off the tonearm base. You will hear a small "click" when the cue lever is properly installed.