How to clean your turntable's stylus
Vinyl may be known for pops and hisses, but it doesn’t have to be that way. Surface noise is almost always preventable. Step 1 is to make sure that your records are clean before playing. We strongly recommend cleaning your records with a simple record brush every few plays. But even when playing clean records, surface noise can be caused by:
- Dust or debris on the stylus
- Damage to the record
In this post, we’ll focus on one of the most common culprit: a dirty stylus. The diamond stylus tip is the only part of the cartridge that actually touches the record - so dust and debris on the stylus can have an enormous impact on sound quality. (To learn more about how the cartridge and stylus work, check out our cartridge guide.)
Why should I clean my stylus?
Cleaning your stylus on a regular basis not only ensures a better listening experience for you, but also ensures a longer life for your records. By practicing good stylus hygiene, you can avoid:
- Playback issues: No cartridge will sound good once it has accumulated layers of dust. Accurate sound reproduction requires close contact between the stylus and record grooves. Dust interferes with this contact, causing muffled or scratchy sound that lacks detail. A dirty stylus is also more likely to jump out of the groove. In fact, stylus debris is one of the most common causes of mistracking.
- Damage to records: Dust, dirt, and other debris act as abrasives when caught between the stylus and the record groove. Every time you play a record, you wear it down a little - a dirty stylus can accelerate this process and lead to a loss of clarity.
Here's what a stylus can look like before (left) and after (right) being cleaned. Can you spot the difference?
OK, I get it. So how do I do it?
There are many stylus cleaning products and techniques available. We’ve chosen three that are simple, fast, and cost-effective. When using any of these techniques, please keep in mind that the stylus is incredibly fragile and must be treated with care at all times.
1. Onzow Zerodust Stylus Cleaner: Onzow claims that this "mysterious material" is "softer than a baby skin and... will never damage a delicate stylus." We don't know about that. But we do know that it's incredibly effective and easy to use. Simply lower your stylus onto the gel pad, then lift and repeat until your stylus tip is free of dust and debris. If your Zerodust starts to look a little dirty, you can run some warm water over it - it will basically last forever. Plus, it comes with a magnifying glass for inspecting your stylus.
2. Stylus Brush: This is the most traditional method, and is recommended by cartridge manufacturer (and brush maker) Ortofon. To use your stylus brush, simply move it across the stylus from back to front - the same direction that a record spins. Some brushes come with cleaning fluid, but we don't recommend using liquid products on your stylus. According to Ortofon, "using liquid cleaners can dissolve glue that binds the stylus to the cantilever... interior parts of the cartridge can be affected seriously by the intrusion of solvents."
3. Mr. Clean Magic Eraser: This is an inexpensive DIY method that has become popular on various audio forums. All you need is a Mr. Clean Magic Eraser, which can be found at just about any hardware store. Start by cutting off a 2” square. Next, place that square on either the plinth or the platter – anywhere that the tonearm can easily reach. Then gently lower the stylus onto the eraser and repeat until the stylus stops leaving residue behind. CAUTION: Some versions of the Magic Eraser have a blue side which is treated with cleaning agents. Make sure you only use the white, untreated side. Do not wet the eraser beforehand.
How often should I clean my stylus?
If you are a regular listener, we suggest cleaning your stylus about once a week. Opinions vary about cleaning frequency – ultimately, the rate of stylus dust accumulation depends on how often you play records and how clean those records are. Regularly cleaning your records before each play is your first line of defense against a dusty stylus. If you have older records with layers of dust in the grooves, it might be time to invest in a record washer.
Keep a close eye on your stylus during your next few listening sessions to get a better sense how quickly dust builds up and where it accumulates. Beware of subtle accumulation right behind the stylus tip. This can be easy to miss, but will cause distortion.